How to Maintain Your Brake Pads on Dodge Ram 3500?

Before working on the front brake pads, it's important to jack up the car, raise its wheels and remove the tires. Following compression, pull the caliper away by lifting the top above the caliper adapter. Check that your brake hose does not hold the caliper assembly and then tuck it aside. Following this, take out the brake shoes from the caliper adapter since ant-rattle springs do not go together. Remove both springs found at the top and bottom of the caliper adapter. During installation, press the brake pistons into caliper bore by placing an older brake shoe between the C-clamp and piston, then clamping the C-clamp. Wiping the caliper mounting adapter and anti-rattle springs is important; lubricate the springs after that with brake grease from Mopar(R). After removing the old top and bottom anti-rattle springs, install new ones and then place in the adapter the inboard and outboard brake shoes. Place the top of the caliper over the rotor with the adapter underneath, push down the bottom and then connect it. Slip the wheel and tire group back onto the vehicle, lower it and practice pressing the brake pedal several times until the brake shoes and pistons are in full contact. Be certain to fill the master cylinder with the correct fluid level.

How to Service and Repair Rear Brake Pads on Dodge Ram 3500?

The repair or service of rear brake pads should begin with cleaning the caliper mounting adapter and anti-rattle springs. Coat the anti-rattle springs with Mopar brake grease, because you cannot mix up these parts. You should then install a new spring on the adjusting end along with another spring on the opposite end. After that, place the inboard brake shoe into the adapter and after that, place the outboard brake shoe in the adapter. Place the caliper's bottom on top of the rotor while the adapter is underneath and then press the caliper's top down onto the adapter. Put the caliper in place, install the set of wheels and tires next and finally lower your car on the jack stands. Stop the car a few times to settle the caliper and brake shoe parts, check the pedal and fill the master cylinder until you see fluid.

OEM Dodge Ram 3500 Brake Pads

Disc Brake Pad Set

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

10 Brake Pads found

View related parts
Dodge Ram 3500 Brake Pads, Rear Part Number: 68049158AA
$120.10 MSRP: $177.00
You Save: $56.90 (33%)
ADD TO CART
Product Specifications
- Other Name: Pad Kit - Rear Disc Brake; Disc Brake Pad Set, Rear; Disc Brake Hardware Kit; Rear Pads; Pad Kit Rear Disc Brake; Disc Brake Pad Set
- Position: Rear
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2009-2010 Dodge Ram 3500 | Laramie, SLT, ST, SXT | 6 Cyl 6.7 L DIESEL, 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 3500 Brake Pads, Front Part Number: 68049148AA
$96.95 MSRP: $149.00
You Save: $52.05 (35%)
ADD TO CART
Product Specifications
- Other Name: Pad Kit - Front Disc Brake; Disc Brake Pad Set, Front; Disc Brake Hardware Kit; Disc Brake Pad Kit; Front Pads; Pad Kit Front Disc Brake
- Position: Front
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2009-2010 Dodge Ram 3500 | Laramie, SLT, ST, SXT | 6 Cyl 6.7 L DIESEL, 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 3500 Pad Kit - Rear Disc Brake Part Number: 1BP00295AA
$47.54 MSRP: $66.85
You Save: $19.31 (29%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: PAD KIT-REAR DISC BRAKE
- Position: Rear
- Replaces: 2AMV2158AB, 2AMV2158AA, 2AMV2158AC, V2019158AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2007-2010 Dodge Ram 3500 | Laramie, SLT, Sport, ST, SXT, TRX4 | 5.7L V8, 5.9L L6, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 6.7L L6, 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 3500 Brake Pads, Rear Part Number: 1BP00297AA
$53.33 MSRP: $75.00
You Save: $21.67 (29%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Shoe Kit - Rear Disc Brake
- Position: Rear
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2006-2008 Dodge Ram 3500 | Laramie, SLT, Sport, ST, SXT, TRX4 | 5.7L V8, 5.9L L6, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 6.7L L6, 8 Cyl 5.7 L GAS
- 2001-2003 Dodge Ram 3500 | 5.7L V8, 5.9L L6, 5.9L V8, 8.0L V10
View related parts
Dodge Ram 3500 Brake Pads, Front Part Number: 1BP00281AA
$62.72 MSRP: $75.00
You Save: $12.28 (17%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Shoe Kit - Front Disc Brake
- Position: Front
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2003-2008 Dodge Ram 3500 | Laramie, SLT, Sport, ST, SXT, TRX4 | 5.7L V8, 5.9L L6, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 6.7L L6, 8 Cyl 5.7 L GAS, 8.0L V10
View related parts
Dodge Ram 3500 Brake Pads, Front Part Number: 5143402AB
Product Specifications
- Other Name: Pad Kit - Front Disc Brake; Disc Brake Pad Set, Front; Disc Brake Hardware Kit; Front Pads; Pad Kit Front Disc Brake
- Position: Front
- Replaces: 5143402AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2005 Dodge Ram 3500 | Laramie, SLT, ST | 6 Cyl 5.9 L DIESEL, 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 3500 Brake Pads, Front Part Number: 4886279AC
Product Specifications
- Other Name: Pad Kit - Front Disc Brake; Disc Brake Hardware Kit; Front Pads
- Position: Front
- Replaces: 4886279AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1994-1999 Dodge Ram 3500 | Base | 10 Cyl 8.0 L GAS, 5.9L L6, 5.9L V8, 6 Cyl 5.9 L DIESEL, 8 Cyl 5.9 L GAS, 8.0L V10
View related parts
Dodge Ram 3500 Brake Pads, Rear Part Number: 5139917AB
Product Specifications
- Other Name: Shoe Kit - Rear Disc Brake; Disc Brake Pad Set, Rear; Disc Brake Hardware Kit; Disc Brake Pad Set; Rear Pads
- Position: Rear
- Replaces: 5139917AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2005 Dodge Ram 3500 | Laramie, SLT, ST | 6 Cyl 5.9 L DIESEL, 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 3500 Brake Pads, Front Part Number: 5093267AB
Product Specifications
- Other Name: Shoe Kit - Front Disc Brake; Disc Brake Pad Set, Front
- Position: Front
- Replaces: 5093267AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2003-2008 Dodge Ram 3500 | Laramie, SLT, Sport, ST, SXT, TRX4 | 10 Cyl 8.0 L GAS, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 3500 Brake Pads, Front Part Number: 5013814AB
Product Specifications
- Other Name: Pad Kit - Front Disc Brake
- Position: Front
- Replaces: 5013814AA, 4874866AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1998-1999 Dodge Ram 3500 | Base | 10 Cyl 8.0 L GAS, 6 Cyl 5.9 L DIESEL, 8 Cyl 5.9 L GAS

Dodge Ram 3500 Brake Pads

Choose OEM Brake Pads that meet Dodge factory standards. Dodge designs and tests every component for precision and durability. Each Brake Pads follows strict manufacturing steps to lock in quality and fit. If your Dodge Ram 3500 matters to you, OEM parts make the smart choice. You'll get the exact look, feel, and performance you expect. Shop genuine Ram 3500 parts at the highly competitive prices online. Enjoy a manufacturer's warranty, a hassle-free return policy, and rapid delivery. No more guesswork with off brands. Get genuine parts with exact fit and true factory performance. Shop with confidence today at JeepPartsDeal.com.

The purpose of the Dodge Ram 3500 Brake Pads is to minimize your vehicle's movement through heat friction. It is the primary means of stopping and slowing the movement of your Dodge Ram 3500. The component boasts a steel backing plate that is either bonded or riveted to an advanced friction mix, its substance being clamped against the rotor surface when hydraulic pressure displaces the caliper. Each rotor uses two Brake Pads that have friction lining which wears out over time. Standards guide timely replacement of minimum thickness, many assemblies include sensors or audible wear indicator that tell the driver when Brake Pads service is needed. The original Brake Pads on a Dodge Ram 3500 provide dependable stopping power for anything from everyday commuting and errands to casual highway driving. However, towing and hauling heavy loads, as well as repeatedly coming to a stop from high-speed, creates heat that can initiate fade if temperatures exceed the thresholds the compound can handle. A routine inspection at roughly 50,000 miles will help ensure Dodge Ram 3500 Brake Pads are within specification and guard against increased stopping distance and rotor damage on any Dodge Ram 3500.

Dodge Ram 3500 Brake Pads Parts and Q&A

Brake Pads, Front
5143402AB
Q:
How to Maintain Your Brake Pads on Dodge Ram 3500?
A:
Before working on the front brake pads, it's important to jack up the car, raise its wheels and remove the tires. Following compression, pull the caliper away by lifting the top above the caliper adapter. Check that your brake hose does not hold the caliper assembly and then tuck it aside. Following this, take out the brake shoes from the caliper adapter since ant-rattle springs do not go together. Remove both springs found at the top and bottom of the caliper adapter. During installation, press the brake Pistons into caliper bore by placing an older brake shoe between the C-clamp and piston, then clamping the C-clamp. Wiping the caliper mounting adapter and anti-rattle springs is important; lubricate the springs after that with brake grease from Mopar(R). After removing the old top and bottom anti-rattle springs, install new ones and then place in the adapter the inboard and outboard brake shoes. Place the top of the caliper over the rotor with the adapter underneath, push down the bottom and then connect it. Slip the wheel and tire group back onto the vehicle, lower it and practice pressing the brake pedal several times until the brake shoes and pistons are in full contact. Be certain to fill the master cylinder with the correct fluid level.
Pad Kit - Rear Disc Brake
1BP00295AA
Q:
How to Service and Repair Rear Brake Pads on Dodge Ram 3500?
A:
The repair or service of rear brake pads should begin with cleaning the caliper mounting adapter and anti-rattle springs. Coat the anti-rattle springs with Mopar brake grease, because you cannot mix up these parts. You should then install a new spring on the adjusting end along with another spring on the opposite end. After that, place the inboard brake shoe into the adapter and after that, place the outboard brake shoe in the adapter. Place the caliper's bottom on top of the rotor while the adapter is underneath and then press the caliper's top down onto the adapter. Put the caliper in place, install the set of wheels and tires next and finally lower your car on the jack stands. Stop the car a few times to settle the caliper and brake shoe parts, check the pedal and fill the master cylinder until you see fluid.