OEM Dodge Ram 3500 Emblem

Dodge Ram 3500 Emblem Parts and Q&A

• Nameplate, Front
  55372159AC
  Q: How to Install an Emblem or Decal on Dodge Ram 3500?

  A:

  Tidy up the spots on the body where you are going to place the name plate by cleaning them well. Rub these areas with a cloth moistened with 50% water and alcohol, then wipe them with a dry, lint-free cloth. Do not allow the room temperature to reach higher than 52°C (125°F) to avoid damaging name plates, decals or the vehicle paint finish by heating only the body panels before trim removal. When temperatures outside are below 21°C (70°F), applying heat from a heat lamp or gun to the name plate, decal and car panel will help the paint adhere properly. After that, peel off the protective layer from the back of the name plate or decal and place it onto the body using the installed guide tape. For correct adhesion, press down evenly with a force of approximately 40 p.s.i. on all parts of the name plate or decal before putting it in place.
• Insulation Fastener
  6503274
  Q: How Are Emblems Attached and Removed on Dodge Ram 3500?

  A:

  Panels on the exterior of the car are fitted with adhesive-strengthened exterior name plates. Place a strip of masking tape along the body, just above the name plate, for help in fixing your name plate in the right place. If it is below 21 degrees C (70 degrees F), you should heat up the emblem using a heat lamp or gun, but not more than 210 degrees C (120 degrees F). Remove the name plate from the window frame using an equivalent or equivalent trim stick C-4755 and discard it. For putting on the name plate, start by removing any leftover materials from where the name plate is placed on the body panel and then dampen a lint-free cloth with equal parts water and alcohol. Dry the area immediately using another clean lint-free cloth. Lift off the back cover of the adhesive tape from the name plate and fix the name plate on the body panel. Keep applying the same level of pressure all over the name plate with your palm. If it's below 21 degrees C (70 degrees F), heat the logo with a lamp or gun to ensure it will stick and do not let the heat exceed 52 degrees C (120 degrees F).