OEM Dodge Sprinter 3500 Wiper Blade

Dodge Sprinter 3500 Wiper Blade Parts and Q&A

• Wiper Blade, Front Driver Side
  68055456AA
  Q: How to Safely and Correctly Service Your Wiper Blade System on Dodge Sprinter 3500?

  A:

  Before working on the front wiper system, remove the key from the ignition lock so the wipers don't start moving by themselves and risk hurting or damaging someone. Don't try to open the Hood before locking your Wiper Arms because both could be damaged. Before springing the wiper arm with force against the glass, make sure the wiper blade is attached to prevent it from hitting and scratching the glass. The right (passenger) arm and the left (driver) blade on the front wiper are unequal in length. The first step is to raise the front wiper arm until the hinge ends up in the over-center position. Hold the blade close to the bracket on the arm tip and slot the pivoting mechanism of the blade into the upper tab on the bracket. Force the pivot-block device up into the bracket until the tabs snap into place and a click is heard. After that, place the wiper blade gently on the glass.
• Blade Assembly Refill
  5133992AA
  Q: How to Remove and Install Wiper Blades on Dodge Sprinter 3500?

  A:

  Unlike most models, in this one, the Wiper Arms and blades are a different length, with the longer one found on the left (driver) side. Select the On mode on the wiper control, run the wipers and move the Ignition Switch to on and off again to place the blade in the space you'll be working in. Lift the arm until the wiper blade comes away from the glass and the arm stops in its highest position. Press the release tab on the latch under the tip of the arm and pull the blade slowly away from the arm to pull the pivot block off the hooked part of the arm. Tool out the hook formation from the backside of the wiper blade superstructure near the pivot block/latch unit, taking care the wiper arm does not contact the glass through its spring. Lower the wiper arm tip slowly on to the glass. While installing, lift the wiper arm up and over onto the over-center hinge, moving it until it is free from the windshield. Then, position the wiper blade on the hook formation on the end of the arm. Push the hook formation through the opening in the wiper blade superstructure ahead of the pivot block/latch unit in order for it to engage with the pivot block. Place the wiper blade pivot block/latch into the hook frame and ensure that the release tab snaps firmly in place, giving you a clear audible click and slowly lower the wiper blade onto the glass.