2009 Chrysler Sebring Camshaft, Timing Chain, Timing Cover, Cam Gear

Cam Gear, Camshaft, Timing Chain, Timing Cover Installation and Repair Tips for 2009 Chrysler Sebring

• Q:

  Can Cam Gear Sprockets and Phasers Be Serviced Independently on 2009 Chrysler Sebring?

  A:

  Phasers and camshaft sprockets are an assembly and cannot be serviced independently. When working on camshaft sprocker bolts use of an impact wrench should be avoided, as it may damage the bolts. Install correctly the camshaft phaser, lifters, and push rods and make sure that all the steps are correct.
• Q:

  How to Remove a Camshaft on 2009 Chrysler Sebring?

  A:

  To remove the camshaft, you must remove the engine cover and the negative battery cable. Remove the cylinder head cover, raise the vehicle and remove the right splash shield. Align camshaft timing marks, mark chain link and release tensioner. Remove camshaft bearing caps, then lift and remove camshafts (secure the timing chain with wire).
• Q:

  How to Remove and Replace a Timing Chain on 2009 Chrysler Sebring?

  A:

  To replace the timing chain, adjust the engine to TDC, align the crankshaft and camshaft timing marks and install the timing chain. Make sure to align and install the tensioner. Crankshaft rotation, check alignment, install cover, bring battery back on, and check fluid levels after engine running.
• Q:

  How to install a timing cover on 2009 Chrysler Sebring?

  A:

  To install the engine timing cover, clean gently on sealing surfaces and apply Mopar(R) engine sealant. Secure cover with bolts, install accessory drive belt tensioner, tighten different components. Finally install cylinder head cover, power steering pump and air cleaner housing and check for leaks and fluid levels.