How to Service and Repair a Transmission Speed Sensor for Output on 2001 Chrysler Town & Country?

For the Transmission Speed Sensor service, first remove the negative terminal cable from the battery and lift the car using a hoist. After that, loosen the connection for the output speed sensor and then remove the sensor from the car. Review the O-ring on your speed sensor and change it if necessary. When positioning the O-ring, use a proper fit, then secure and tighten the input speed sensor to 27 Nm (20 ft. lbs.). Afterward, link the speed sensor connector again and insert the battery negative cable which should finish the procedure.

OEM 2001 Chrysler Town & Country Speed Sensor

Speed Control Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Speed Sensor found

View related parts
2001 Chrysler Town & Country Vehicle Speed Sensor Part Number: 4707839AA
$67.79 MSRP: $102.00
You Save: $34.21 (34%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Vehicle Speed; Speedometer Sensor; Sensor Vehicle Speed
- Item Weight: 0.50 Pounds
- Item Dimensions: 3.6 x 1.8 x 1.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4707839AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2001 Chrysler Town & Country Submodels:
- EL, EX, LX, LXi, Limited | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS

2001 Chrysler Town & Country Speed Sensor Parts and Q&A

Q: How to Service and Repair a Transmission Speed Sensor for Output on 2001 Chrysler Town & Country?
A: For the Transmission Speed Sensor service, first remove the negative terminal cable from the battery and lift the car using a hoist. After that, loosen the connection for the output speed sensor and then remove the sensor from the car. Review the O-ring on your speed sensor and change it if necessary. When positioning the O-ring, use a proper fit, then secure and tighten the input speed sensor to 27 Nm (20 ft. lbs.). Afterward, link the speed sensor connector again and insert the battery negative cable which should finish the procedure.