How to Maintain a MAP Sensor for Optimal Performance on 2002 Chrysler Town & Country?

Before servicing the Manifold Absolute Pressure (MAP) Sensor, remove the negative battery cable. Second, take out the vacuum hose and the mounting screws on the MAP sensor, then cut off its electrical connector and take out the sensor. To install the sensor, add it and then screw it in place, tightening the screws to 1.7 Nm on plastic manifolds and 3.3 Nm on aluminum manifolds. Then, fit the electrical end of the cable back to the sensor and attach the vacuum hose again. Now go ahead and reattach the negative battery cable where it should be.

OEM 2002 Chrysler Town & Country MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 MAP Sensor found

View related parts
2002 Chrysler Town & Country M.A.P. Sensor Part Number: 68002763AA
$112.00 MSRP: $167.00
You Save: $55.00 (33%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; Pressure Sensor; MAP Sensor
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.0 x 2.4 x 2.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68002763AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2002 Chrysler Town & Country Submodels:
- Base, EL, EX, LX, LXi, Limited, Touring | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS

2002 Chrysler Town & Country MAP Sensor Parts and Q&A

Q: How to Maintain a MAP Sensor for Optimal Performance on 2002 Chrysler Town & Country?
A: Before servicing the Manifold Absolute Pressure (MAP) Sensor, remove the negative battery cable. Second, take out the vacuum hose and the mounting screws on the MAP sensor, then cut off its electrical connector and take out the sensor. To install the sensor, add it and then screw it in place, tightening the screws to 1.7 Nm on plastic manifolds and 3.3 Nm on aluminum manifolds. Then, fit the electrical end of the cable back to the sensor and attach the vacuum hose again. Now go ahead and reattach the negative battery cable where it should be.