How to Service a MAP Sensor on 2003 Chrysler Town & Country?

The first step in service the Manifold Pressure/Vacuum Sensor is to unplug the negative battery wire. After that, detach the vacuum hose and its screws from the manifold absolute pressure (MAP) sensor and take out the electrical connector before removing the sensor. The first step is to install the sensor and then screw it in tightly at 1.7 Nm for plastic and 3.3 Nm for aluminum manifolds. Once you've done that, link the electrical connector to the sensor and set up the vacuum hose in its original position. Then, link the battery's negative post to the negative cable.

OEM 2003 Chrysler Town & Country MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 MAP Sensor found

View related parts
2003 Chrysler Town & Country M.A.P. Sensor Part Number: 68002763AA
$112.00 MSRP: $167.00
You Save: $55.00 (33%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; Pressure Sensor; MAP Sensor
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.0 x 2.4 x 2.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68002763AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2003 Chrysler Town & Country Submodels:
- Base, EL, EX, LX, LXi, Limited, Touring | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS

2003 Chrysler Town & Country MAP Sensor Parts and Q&A

Q: How to Service a MAP Sensor on 2003 Chrysler Town & Country?
A: The first step in service the Manifold Pressure/Vacuum Sensor is to unplug the negative battery wire. After that, detach the vacuum hose and its screws from the manifold absolute pressure (MAP) sensor and take out the electrical connector before removing the sensor. The first step is to install the sensor and then screw it in tightly at 1.7 Nm for plastic and 3.3 Nm for aluminum manifolds. Once you've done that, link the electrical connector to the sensor and set up the vacuum hose in its original position. Then, link the battery's negative post to the negative cable.