Other Name: Plate - Seat Belt; Plate; Wheelhouse Inner 2ND Rear Seat Belt Swivel Mounting Assembly.
Item Weight: 0.70 Pounds
Item Dimensions: 1.0 x 0.8 x 0.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 4716394
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2005 Dodge Grand Caravan Submodels:
Anniversary Edition, Base, C/V, EL, ES, EX, LE, SE, SE Plus, SXT, Sport | 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.3 L CNG, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS
Other Name: Seat Belt-3 Passenger Inner; Seat Belt Receptacle, Rear Left; Latch; Seat Belt 3 Passenger Inner
Position: Rear Inner
Item Weight: 1.40 Pounds
Item Dimensions: 7.4 x 4.2 x 3.5 inches
Condition: New
Fitment Type: Direct Replacement
SKU: RK991D5AB
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2005 Dodge Grand Caravan Submodels:
Anniversary Edition, Base, C/V, EX, SE, SE Plus, SXT | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS
| Page 1 of 2 |Next >
1-20 of 40 Results
2005 Dodge Grand Caravan Seat Belt Parts and Q&A
Q: How to Maintain and Repair a Seat Belt Retractor in the Second Row on 2005 Dodge Grand Caravan?
A: Remove the two rows of seats in the long wheelbase vehicle and then take out the first row's seat belt lower and upper bolts to access the second row right outboard seat belt retractor and rear HVAC. After that, remove the sill plate and the liftgate trim and then take out the bolted lower and upper seat belt anchor points. Remove the trim at the D-pillar and then reach into the rear to take out the speaker connector. Remove the trim bolster, together with its screws and the panel, from the quarter area. Get access to the seat belt retractor fasteners by loosening the HVAC unit, taking out the bracket around it and removing the duct and the HVAC unit fasteners from the inner quarter panel. Remove the rear HVAC unit so that you have room to take off the bolts standing between the seat belt guide loop and the inner quarter panel, as well as between the retractor and the inner quarter panel. Lastly, take out the second row seat belt and retractor from the car. During installation, place the second row seat belt and retractor, slide outward on the HVAC unit and fasten the retractor to the inner quarter panel with a bolt, tightening it to 39 Nm (29 ft. lbs.). Fit the bolts for the seat belt guide loop, attach the fasteners for the HVAC unit, secure the air duct and place the trim panel retaining bracket around the HVAC unit. Next, put the quarter trim panel and screws back in place, after that fit the quarter trim bolster. Connect up the speaker connector and then put the D-pillar trim piece in place. Install the lower and upper seat belt anchor bolts for the second row, each bolt set at 39 Nm (29 ft. lbs.), along with the upper liftgate trim, liftgate sill plate, then bolt the upper and lower anchor bolts for the first row at the same torque level.