JeepParts
My Garage
My Account
Cart
OEM 2007 Dodge Nitro Starter Motor
Starter Ignition- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Starter motors found
2007 Dodge Nitro Starter Part Number: 4801269AD
Product Specifications- Other Name: Starter - Engine; Starter Motor; Starter Motor Reman; Starters; Starter Engine
- Replaces: 4801269AC
- Item Weight: 8.20 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4801269AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2007 Dodge Nitro Starter Part Number: 4801292AC
Product Specifications- Other Name: Starter - Engine; Starter Motor; Starter Motor Reman; Starters; Starter Engine
- Replaces: 4801292AB
- Item Weight: 7.70 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4801292AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2007 Dodge Nitro Starter Motor Parts and Q&A
- Q: How to Install a Starter Motor for a 3.7L Engine on 2007 Dodge Nitro?A: When installing the starter motor, first turn the assembly until it sits inside the transmission opening. After that, place and tighten the two starter mounting bolts using the Torque Specifications as a guide. Put the battery cable assembly on the stud at the same time that you push the connector onto the solenoid and tighten the nut to the torque specified for the job. Following that, put the starter heat shield into place and tighten the two bolts. If the vehicle has a Four Wheel Drive system, where you would normally put the front propeller shaft. In the end, bring the vehicle to the ground and attach the negative battery cable.
Related 2007 Dodge Nitro Parts
2007 Dodge Nitro Alternator
2007 Dodge Nitro Battery Cable
2007 Dodge Nitro Battery Tray
2007 Dodge Nitro Car Batteries