How to Install a Yaw Sensor on 2008 Chrysler Sebring?

To install the yaw rate sensor secure on the floor pan tunnel 2 nuts tighten 9 Nm. Connect Wiring Harness Installation of Center Console Make sure the negative cable of the battery is connected. Finally, run the Verification Test and clear the faults, if any.

OEM 2008 Chrysler Sebring Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Yaw Sensor found

View related parts
2008 Chrysler Sebring Yaw Rate Sensor Part Number: 5033322AC
Product Specifications
- Other Name: Module - Electronic Stability; Control Module; Stab Control Module; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 4.10 Pounds
- Item Dimensions: 10.5 x 6.3 x 6.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033322AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Chrysler Sebring Submodels:
- LX, Limited, Touring | 4 Cyl 2.4 L GAS, 6 Cyl 2.7 L FLEX, 6 Cyl 2.7 L GAS, 6 Cyl 3.5 L GAS

2008 Chrysler Sebring Yaw Sensor Parts and Q&A

Q: How to Install a Yaw Sensor on 2008 Chrysler Sebring?
A: To install the yaw rate sensor secure on the floor pan tunnel 2 nuts tighten 9 Nm. Connect Wiring Harness Installation of Center Console Make sure the negative cable of the battery is connected. Finally, run the Verification Test and clear the faults, if any.