OEM 2008 Dodge Viper Throttle Body

2008 Dodge Viper Throttle Body Parts and Q&A

• Q: How to install a Throttle Body on 2008 Dodge Viper?

  A: The next step is to lay the new throttle body gasket onto the throttle body. Wire the throttle body into place and fasten all the bolts by hand. Attach the new throttle body connector harness clip to the harness and the throttle body and fasten the electrical connector to the electronic throttle control. Do not over-tighten because that could damage the throttle body, gaskets, bolts or intake manifold; therefore, make sure to tighten the bolts to 8 Nm (71 in. lbs.) after crossing them over each other. After completing the throttle, put in the air cleaner and link the negative battery cable, using about 10 Nm (90 in. lbs.) to tighten the cable. Lastly, connect a scan tool and perform the Etc Relearn function.