JeepParts
My Garage
My Account
Cart
OEM 2009 Chrysler Sebring Oxygen Sensor
Oxygen O2 Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Oxygen Sensors found
2009 Chrysler Sebring Oxygen Sensor, Front Part Number: 56029084AA
$152.73 MSRP: $231.00You Save: $78.27 (34%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Sensor - Oxygen; Oxygen Sensor, Front, Front Right, Rear; Rear Oxygen Sensor; Front Oxygen Sensor; Sensor Oxygen
- Position: Front
- Item Weight: 0.60 Pounds
- Item Dimensions: 1.8 x 3.4 x 6.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029084AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2009 Chrysler Sebring Oxygen Sensor, Front Driver Side Part Number: 56029049AA
$97.32 MSRP: $144.00You Save: $46.68 (33%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Sensor - Oxygen; Oxygen Sensor, Front, Front Left, Front Right, Rear, Rear Left, Rear Right; Rear Oxygen Sensor; Front Oxygen Sensor; Upper Oxygen Sensor; Lower Oxygen Sensor; Sensor Oxygen
- Position: Front Driver Side
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.9 x 3.3 x 5.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029049AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2009 Chrysler Sebring Oxygen Sensor Parts and Q&A
- Q: How to Install Upstream and Downstream Oxygen Sensors on 2009 Chrysler Sebring?A: Always wait until the engine has cooled before starting the O2S installation, because the exhaust manifold, pipes and catalytic converter can burn you. For this step, use an O2S removal tool and make sure the new sensors have the anti-seize compound already, so you will not need to use any more. Screw the O2S into the catalytic converter, reaching a tightening torque of 41 Nm (30 ft. lbs.). After that, join the O2S pigtail harness to the engine harness and fasten the O2S wire harness clips to the engine or body using the provided clips if so equipped. When working on the upstream oxygen sensor, still observe proper engine temperature and use the O2S removal tool. Hook the O2S to the exhaust pipe and tighten it to 41 Nm (30 ft. lbs.), then link the O2S pigtail harness to the engine's harness and attach the wire harness clips to the engine or body if they're included.
Related 2009 Chrysler Sebring Parts
2009 Chrysler Sebring Ignition Coil
2009 Chrysler Sebring Antenna Mast
2009 Chrysler Sebring Camshaft Position Sensor
2009 Chrysler Sebring Coolant Temperature Sensor
2009 Chrysler Sebring Dimmer Switch
2009 Chrysler Sebring Engine Control Module
2009 Chrysler Sebring Hazard Warning Switch
2009 Chrysler Sebring Ignition Control Module
2009 Chrysler Sebring Intake Manifold Temperature Sensor
2009 Chrysler Sebring Knock Sensor
2009 Chrysler Sebring MAP Sensor
2009 Chrysler Sebring Relay