How to Service and Repair a Yaw Sensor on 2009 Dodge Challenger?

To repair the yaw rate sensor, first disconnect the negative battery cable. Next, take off the floor console and disconnect the sensor wiring harness. Then, remove the nuts for fastening the sensor to the floor pan tunnel and finally, remove the dynamics sensor from the vehicle.

OEM 2009 Dodge Challenger Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Yaw Sensors found

View related parts
2009 Dodge Challenger Yaw Rate Sensor Part Number: 56029427AA
$445.41 MSRP: $649.00
You Save: $203.59 (32%)
ADD TO CART
Product Specifications
- Other Name: Sensor - Dynamics; Electronic Stability System Control Module; ABS Control Module; Control Module; Stab Control Module; Sensor Dynamics Lateral Acceleration And Yaw Rate.
- Item Weight: 0.60 Pounds
- Item Dimensions: 5.1 x 4.1 x 2.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029427AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
View related parts
2009 Dodge Challenger Yaw Rate Sensor Part Number: 56029483AA
Product Specifications
- Other Name: Module - Dynamics; Electronic Stability System Control Module; ABS Control Module; Control Module; Lateral Accelerometer Sensor; Electronic Stability Module.
- Item Weight: 0.60 Pounds
- Item Dimensions: 3.8 x 4.0 x 2.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029483AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2009 Dodge Challenger Submodels:
- R/T, SE, SRT8 | 6 Cyl 3.5 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.1 L GAS

2009 Dodge Challenger Yaw Sensor Parts and Q&A

Q: How to Service and Repair a Yaw Sensor on 2009 Dodge Challenger?
A: To repair the yaw rate sensor, first disconnect the negative battery cable. Next, take off the floor console and disconnect the sensor wiring harness. Then, remove the nuts for fastening the sensor to the floor pan tunnel and finally, remove the dynamics sensor from the vehicle.