How to Install a Yaw Sensor and What Steps Should You Follow Next on 2010 Dodge Challenger?

To install the yaw sensor, place the sensor over the floor pan tunnel studs and tighten with mounting nuts 12NM. Connect the wiring harness, install the floor console and reconnect the negative battery cable. Finally, perform a Verification Test and clear any faults.

OEM 2010 Dodge Challenger Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Yaw Sensor found

View related parts
2010 Dodge Challenger Yaw Rate Sensor Part Number: 56029483AA
Product Specifications
- Other Name: Module - Dynamics; Electronic Stability System Control Module; ABS Control Module; Control Module; Lateral Accelerometer Sensor; Electronic Stability Module.
- Item Weight: 0.60 Pounds
- Item Dimensions: 3.8 x 4.0 x 2.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029483AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2010 Dodge Challenger Submodels:
- R/T, SE, SRT8 | 6 Cyl 3.5 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.1 L GAS

2010 Dodge Challenger Yaw Sensor Parts and Q&A

Q: How to Install a Yaw Sensor and What Steps Should You Follow Next on 2010 Dodge Challenger?
A: To install the yaw sensor, place the sensor over the floor pan tunnel studs and tighten with mounting nuts 12NM. Connect the wiring harness, install the floor console and reconnect the negative battery cable. Finally, perform a Verification Test and clear any faults.