OEM 2010 Dodge Avenger Cruise Control Switch

2010 Dodge Avenger Cruise Control Switch Parts and Q&A

• Q: How to Install the Cruise Control Switch and Related Components in the Steering Wheel on 2010 Dodge Avenger?

  A: Post the speed control switch on to the locating point in the steering wheel and check that the seal is properly positioned around it. Affix the speed control switch to the drive system using two mounting screws which you should tighten to 1.6 Nm (15 ins. lbs.). Put the electrical connector on the end of the speed control switch. Then, put the horn switch on the steering wheel and secure it with proper screws, tightening them until you have 8 Nm (71 ins. lbs.) of force. Install the driver's side air bag, then attach the negative battery cable and attach it with a 5 Nm or 45 in. lbs. tightening. Check to see if the vehicle's components and the system operate properly.