OEM Chrysler Cirrus Bumper Cover

Chrysler Cirrus Bumper Cover Parts and Q&A

• Bumper Cover
  4695148
  Q:

  How to remove and install the rear Bumper Cover on Chrysler Cirrus?

  A:

  To remove the rear bumper fascia, first release the decklid latch and open the decklid. Next, remove the left rear tail lamp and disengage the license plate wire connector from the tail lamp. For CP-models, also remove the right rear tail lamp. Then, remove the push-in fasteners that attach the fascia to the quarter panel inside the tail lamp cavities, followed by the push-in fasteners that secure the decklid slam bumpers to the top of the fascia. Remove the push-in fastener that connects the center of the fascia to the rear closure panel, and the screws that attach the fascia to the rear wheel house splash shields. Additionally, remove the push-in fastener that connects the fascia to the quarter panel at the wheel house opening. Slide the fascia rearward to disengage the hooks holding it to the bottom of the quarter panel, and then remove the fascia from the vehicle. For installation, position the fascia on the vehicle and slide it forward to engage the hooks at the bottom of the quarter panel. Install the push-in fastener that connects the center of the fascia to the rear closure panel, followed by the push-in fasteners for the decklid slam bumpers at the top of the fascia. Install the push-in fasteners that attach the fascia to the quarter panel at the wheel house opening, and the screws for the rear wheel house splash shields. For CP-models, install the push-in fasteners that attach the fascia to the quarter panel inside the tail lamp cavities. Finally, engage the license plate wire connector to the left tail lamp and install the tail lamps.
• Bumper Cover, Front
  4805379AA
  Q:

  How to service the front bumper cover on Chrysler Cirrus?

  A:

  To service the front bumper fascia, begin by releasing the hood latch and opening the hood. Remove the front wheel house splash shields as necessary to access the fascia fasteners. Next, take out the fasteners that attach the bottom of the fascia to the radiator closure panel and disengage the fog lamp wire connector from the body harness if equipped. Remove the fasteners that secure the fascia to the front fenders and then take the fascia off the vehicle. For installation, position the fascia back onto the vehicle and install the fasteners to attach it to the front fenders. Reconnect the fog lamp wire connector to the body wire harness if equipped, then secure the bottom of the fascia to the radiator closure panel with fasteners. Finally, reinstall the front wheel house splash shields.