To put on the cover, first shove the two upholstery wires under the edges of the fabric sleeves. After that, fold the cover and lay it on the foam rubber pad. Insert the threaded end of the middle longitudinal upholstery wire into the foam rubber pad through the fabric straps, then connect it to the wire. Fit the end of the rear lateral upholstery wire through the fabric tube in the cover. Fasten the side and rear retainers, next pull the cover beside the foam rubber pad to hide it over it. Instal one more retaining clip in the front clip groove, on the center. Put the cushion shell in place, cover it up and attach the cover to the shell evenly. Whisk both fabric tabs into the cushion case and cut away the excess material from the side. Always place the cover flap in the right place before fitting the cushion.