How to service and repair the Power Trunk Liftgate Lock Actuator on Chrysler Town & Country?

To service and repair the Power Trunk / Liftgate Lock Actuator, first disconnect and isolate the battery negative cable. Open the liftgate and remove the lower liftgate trim panel. Disconnect the power latch electrical connector and remove the three latch retaining bolts. Unhook the key cylinder link rod from the key cylinder while holding the latch assembly. Place the latch assembly on a bench and locate the three wires leading from the actuator portion. Disengage the main connector retaining push pins from the latch actuator housing and back the three wires out of the main latch electrical connector. Flip the latch assembly over and remove the latch actuator retaining screw(s) to take out the latch actuator from the latch assembly.

How to install the Liftgate Lock Actuator on Chrysler Town & Country?

The latch actuator ought to be attached to the latch assembly. Secure it with the three retaining screws. Then, install the Power Trunk / Liftgate Lock Actuator. Join the three wires in the electrical connector of the latch in the correct wire cavities to avoid damage to the latch actuator. Fasten the locking connector retention push pins on the latch actuator housing. Subsequently, you will have to engage the link rod of the key cylinder with the key cylinder. Position the latch properly and install the latch with three new bolts. Torque the new latch retaining bolts to 10 Nm (90 in.lbs.). Attach the power latch electrical connector and install the liftgate lower trim panel. Reconnect the battery negative cable. Using a suitable scan tool, check for any power liftgate control module diagnostic trouble codes (DTCs) related to the power latch and erase them. The power liftgate system and the power cinch/release latch operation shall be verified by cycling the power liftgate through one complete open/close cycle, allowing the control module to relearn its cycle with the new components. At last, check that the power liftgate can be operated manually by turning the lock cylinder with the liftgate key and pulling the door open by the exterior liftgate handle/switch.

OEM Chrysler Town & Country Liftgate Lock Actuator

Tailgate Latch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

7 Liftgate Lock Actuators found

View related parts
Chrysler Town & Country Lock Actuator, Rear Part Number: 4589581AL
$380.12 MSRP: $575.00
You Save: $194.88 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Latch - Liftgate; Rear Trunk Lock Actuator Motor; Door Lock Actuator; Trunk Latch.; Lock; Latch; Latch Lift Gate
- Position: Rear
- Replaces: 4589581AF, 4589581AI, 4589581AC, 4589581AB, 4589581AE, 4589581AG, 4589581AJ, 4589581AK, 4589581AD, 4589581AH, 4589581AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2008-2016 Chrysler Town & Country | 30th Anniversary Edition, Limited, Limited Platinum, LX, S, Touring, Touring L, Touring Plus, Walter P. Chrysler Signature Series | 3.3L V6, 3.6L V6, 3.8L V6, 4.0L V6, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS
View related parts
Chrysler Town & Country Lock Actuator Part Number: 4675782
$36.08 MSRP: $45.74
You Save: $9.66 (22%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Motor - Electrode Sliding Door & Lift Gate; Tailgate Lock Actuator; Trunk Lock Actuator; Door Lock Actuator.; Actuator; Motor Assembly, Liftgate Handle; Motor Door Lock
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1996-2000 Chrysler Town & Country | Base, LX, LXi, Limited, SX | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS
View related parts
Chrysler Town & Country Liftgate Latch Part Number: 4589243AH
$184.17 MSRP: $276.00
You Save: $91.83 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Latch-Liftgate; Latch; Latch Lift Gate
- Position: Rear
- Replaces: 4589243AG, 4589243AF, 4589243AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2009-2016 Chrysler Town & Country | 30th Anniversary Edition, Limited, Limited Platinum, LX, S, Touring, Touring L | 3.3L V6, 3.6L V6, 3.8L V6, 4.0L V6, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
View related parts
Chrysler Town & Country Lock Actuator, Rear Part Number: 4589243AC
$78.97 MSRP: $117.00
You Save: $38.03 (33%)
ADD TO CART
Product Specifications
- Other Name: Latch - Liftgate; Rear Trunk Lock Actuator Motor; Door Lock Actuator; Trunk Latch.; Latch; Latch Lift Gate
- Position: Rear
- Replaces: 4589243AB, 4589243AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2008-2010 Chrysler Town & Country | Limited, LX, Touring, Touring Plus, Walter P. Chrysler Signature Series | 3.3L V6, 3.8L V6, 4.0L V6, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS
View related parts
Chrysler Town & Country Lock Actuator, Rear Part Number: 5019038AA
$198.89 MSRP: $212.00
You Save: $13.11 (7%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Actuator - Fuel Control; Liftgate Latch; Tailgate Lock Motor; Trunk Lock Motor; Door Lock Actuator; Trunk Latch.; Actuator; Latch; Actuator Power Latch
- Position: Rear
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2001-2007 Chrysler Town & Country | Base, EL, EX, LX, LXi, Limited, Touring | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS
View related parts
Chrysler Town & Country Lock Actuator Part Number: 5017678AA
$49.02 MSRP: $75.00
You Save: $25.98 (35%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Actuator - Power Latch; Tailgate, Trunk, and Door Lock Motor.; Actuator; Actuator Power Latch
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2001-2007 Chrysler Town & Country | Base, EL, EX, LX, LXi, Limited, Touring | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS
View related parts
Chrysler Town & Country Lock Actuator Part Number: 5017887AA
$244.80 MSRP: $322.00
You Save: $77.20 (24%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Actuator - Power Latch; Tailgate, Trunk, and Door Lock Motor.; Actuator; Actuator Power Latch
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2001-2007 Chrysler Town & Country | Base, EL, EX, LX, LXi, Limited, Touring | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS

Chrysler Town & Country Liftgate Lock Actuator

Choose OEM Liftgate Lock Actuator that meet Chrysler factory standards. Chrysler designs and tests every component for precision and durability. Each Liftgate Lock Actuator follows strict manufacturing steps to lock in quality and fit. If your Chrysler Town & Country matters to you, OEM parts make the smart choice. You'll get the exact look, feel, and performance you expect. Shop genuine Town & Country parts at the highly competitive prices online. Enjoy a manufacturer's warranty, a hassle-free return policy, and rapid delivery. No more guesswork with off brands. Get genuine parts with exact fit and true factory performance. Shop with confidence today at JeepPartsDeal.com.

Chrysler Town & Country Liftgate Lock Actuator Parts and Q&A

Lock Actuator, Rear
5019038AA
Q:
How to service and repair the Power Trunk Liftgate Lock Actuator on Chrysler Town & Country?
A:
To service and repair the Power Trunk / Liftgate Lock Actuator, first disconnect and isolate the battery negative cable. Open the liftgate and remove the lower liftgate trim panel. Disconnect the power latch electrical connector and remove the three latch retaining bolts. Unhook the key cylinder link rod from the key cylinder while holding the latch assembly. Place the latch assembly on a bench and locate the three wires leading from the actuator portion. Disengage the main connector retaining push pins from the latch actuator housing and back the three wires out of the main latch electrical connector. Flip the latch assembly over and remove the latch actuator retaining screw(s) to take out the latch actuator from the latch assembly.
Lock Actuator
5017678AA
Q:
How to install the Liftgate Lock Actuator on Chrysler Town & Country?
A:
The latch actuator ought to be attached to the latch assembly. Secure it with the three retaining screws. Then, install the Power Trunk / Liftgate Lock Actuator. Join the three wires in the electrical connector of the latch in the correct wire cavities to avoid damage to the latch actuator. Fasten the locking connector retention push pins on the latch actuator housing. Subsequently, you will have to engage the link rod of the key cylinder with the key cylinder. Position the latch properly and install the latch with three new bolts. Torque the new latch retaining bolts to 10 Nm (90 in.lbs.). Attach the power latch electrical connector and install the liftgate lower trim panel. Reconnect the battery negative cable. Using a suitable scan tool, check for any power liftgate control module diagnostic trouble codes (DTCs) related to the power latch and erase them. The power liftgate system and the power cinch/release latch operation shall be verified by cycling the power liftgate through one complete open/close cycle, allowing the control module to relearn its cycle with the new components. At last, check that the power liftgate can be operated manually by turning the lock cylinder with the liftgate key and pulling the door open by the exterior liftgate handle/switch.