To install the front door exterior handle, position the exterior handle to the mounting holes on the outside of the door. From the inside, install and tighten the three screws that secure the exterior handle to the door, ensuring they are tightened to 5 Nm (44 in. lbs.). For the driver side handle, reach into the back of the door shell to engage the lock actuator link to the lock cylinder and snap the plastic clip over the link to secure it. Next, engage the latch release link to the exterior door handle and secure it with the plastic clip. Hand-start the upper screw into the pull cup bracket and position it into the keyed hole on the inside of the front door. Install and tighten the screw that secures the bottom of the pull cup bracket and the bottom of the window regulator rear rail to the inside of the front door to 11 Nm (100 in. lbs.), then tighten the screw that secures the top of the pull cup bracket to 10 Nm (90 in. lbs.). Finally, reinstall the watershield, speaker, and trim panel onto the inside of the front door.