How to install a Transmission Oil Cooler on Dodge Durango?

The first step to transmission oil cooler installation involves positioning the cooler into the vehicle and then installing the lower transmission cooler mounting bolt to a torque specification of 10 Nm (90 in. lbs.). After that, attach the transmission cooler lines and bring down the vehicle. Next, the upper transmission cooler mounting bolt can be installed, which should also be tightened to 10 Nm (90 in. lbs.). Finally, install the upper condenser/radiator seal. Last comes checking the transmission fluid.

How should the Combination TPIM/Transmission Oil Cooler be serviced and repaired on Dodge Durango?

In order to service and repair Combination TPIM/Transmission Oil Cooler, make sure to first do the HEV specific high voltage power down and high voltage isolation check procedures. Disconnect the negative battery cable. Be careful not to create a Battery Pack Control Module (BPCM) SOC mismatch. Take care not to disconnect the 12 V battery within two minutes of the last ignition key transition from the Off to Run position. Subsequently, drain the cooling system, and remove the coolant pump. Utilize Tool 9005 to disconnect the four transmission cooler lines and unclip the three cooler lines at the radiator. Remove coolant hose and disconnect electrical connector for temperature sensor. Thereafter, remove the upper cooler mounting bolts two times and the lower cooler mounting bolts. Lastly, remove the Combination TPIM/Transmission Oil Cooler from underneath the vehicle.

OEM Dodge Durango Transmission Oil Cooler

Trans Oil Cooler

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

9 Transmission Oil Coolers found

View related parts
Dodge Durango Transmission Cooler Part Number: 68596421AA
$292.83 MSRP: $442.00
You Save: $149.17 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Cooler - Transmission Oil; Oil Cooler
- Replaces: 68377852AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2015-2021 Dodge Durango | Citadel, GT, GT Plus, Limited, Pursuit, R/T, Rallye, SXT, SXT Plus, Special Service | 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 8 Cyl 5.7 L GAS
View related parts
Dodge Durango Cooler Transmission Oil Part Number: 68232604AB
$309.40 MSRP: $467.00
You Save: $157.60 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Cooler - Transmission Oil
- Replaces: 68232604AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2015-2020 Dodge Durango | Citadel, Limited, Pursuit, R/T, Special Service | 3.6L V6, 5.7L V8, 8 Cyl 5.7 L GAS
View related parts
Dodge Durango Transmission Cooler Part Number: 68596478AA
$186.42 MSRP: $277.00
You Save: $90.58 (33%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Cooler - Transmission Oil; Oil Cooler
- Replaces: 68480077AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2021-2025 Dodge Durango | Citadel, GT, GT Plus, GT Premium, Pursuit, R/T, R/T Hemi Orange, R/T Plus, R/T Premium, Special Service, SXT, SXT Plus | 3.6L V6, 5.7L V8, 6 Cyl 3.6 L GAS, 8 Cyl 5.7 L GAS
View related parts
Dodge Durango Transmission Cooler Part Number: 52029009AB
$167.68 MSRP: $249.00
You Save: $81.32 (33%)
Product Specifications
- Other Name: Cooler - Transmission Oil; Automatic Transmission Oil Cooler; Auxiliary Oil Cooler; Cooler Transmission Oil
- Replaces: 52029008AB, 52029009AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2004-2009 Dodge Durango | Adventurer, Limited, SE, SLT, ST, SXT | 3.7L V6, 4.7L V8, 5.7L V8, 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS
View related parts
Dodge Durango Transmission Cooler Part Number: 52105585AA
Product Specifications
- Other Name: Cooler - Auxiliary Oil; Automatic Transmission Oil Cooler; Cooler Auxiliary Oil
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1998-1999 Dodge Durango | Base, SLT, SLT Plus | 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS
View related parts
Dodge Durango Transmission Cooler Part Number: 52029174AA
Product Specifications
- Other Name: Cooler - Transmission Oil; Automatic Transmission Oil Cooler
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2004 Dodge Durango | Limited, SLT, ST | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS
View related parts
Dodge Durango Transmission Cooler Part Number: 4883713AB
Product Specifications
- Other Name: Cooler - Auxiliary Oil; Automatic Transmission Oil Cooler; Cooler Auxiliary Oil
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1998-1999 Dodge Durango | Base, SLT, SLT Plus | 6 Cyl 3.9 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS
View related parts
Dodge Durango Transmission Cooler Part Number: 52028779AB
Product Specifications
- Other Name: Cooler - Auxiliary Oil; Automatic Transmission Oil Cooler; Cooler Auxiliary Oil
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2000-2003 Dodge Durango | Base, R/T, SLT, SLT Plus, SXT, Sport | 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS
View related parts
Dodge Durango Transmission Cooler Part Number: 52028916AC
Product Specifications
- Other Name: Fan - Cooling; Engine Cooling Fan Clutch Blade; Radiator Fan Assembly; Fan Blade; Fan Cooling
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2000-2009 Dodge Durango | Adventurer, Base, Limited, R/T, SE, SLT, SLT Plus, ST, SXT, Sport | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 5.9 L GAS

Dodge Durango Transmission Oil Cooler

Choose OEM Transmission Oil Cooler that meet Dodge factory standards. Dodge designs and tests every component for precision and durability. Each Transmission Oil Cooler follows strict manufacturing steps to lock in quality and fit. If your Dodge Durango matters to you, OEM parts make the smart choice. You'll get the exact look, feel, and performance you expect. Shop genuine Durango parts at the highly competitive prices online. Enjoy a manufacturer's warranty, a hassle-free return policy, and rapid delivery. No more guesswork with off brands. Get genuine parts with exact fit and true factory performance. Shop with confidence today at JeepPartsDeal.com.

Dodge Durango Transmission Oil Cooler Parts and Q&A

Transmission Cooler
52028916AC
Q:
How to install a Transmission Oil Cooler on Dodge Durango?
A:
The first step to transmission oil cooler installation involves positioning the cooler into the vehicle and then installing the lower transmission cooler mounting bolt to a torque specification of 10 Nm (90 in. lbs.). After that, attach the transmission cooler lines and bring down the vehicle. Next, the upper transmission cooler mounting bolt can be installed, which should also be tightened to 10 Nm (90 in. lbs.). Finally, install the upper condenser/radiator seal. Last comes checking the transmission fluid.
Transmission Cooler
52029009AB
Q:
How should the Combination TPIM/Transmission Oil Cooler be serviced and repaired on Dodge Durango?
A:
In order to service and repair Combination TPIM/Transmission Oil Cooler, make sure to first do the HEV specific high voltage power down and high voltage isolation check procedures. Disconnect the negative battery cable. Be careful not to create a Battery Pack Control Module (BPCM) SOC mismatch. Take care not to disconnect the 12 V battery within two minutes of the last ignition key transition from the Off to Run position. Subsequently, drain the cooling system, and remove the coolant pump. Utilize Tool 9005 to disconnect the four transmission cooler lines and unclip the three cooler lines at the radiator. Remove coolant hose and disconnect electrical connector for temperature sensor. Thereafter, remove the upper cooler mounting bolts two times and the lower cooler mounting bolts. Lastly, remove the Combination TPIM/Transmission Oil Cooler from underneath the vehicle.