You should deal with the speed control button in the
Steering Wheel carefully, since it is connected to the clock spring device below the
Air Bag module. Start by removing the air cleaner's lid and then unplug both the inlet air temperature sensor and the makeup air hose. Interrupt the negative battery connection next and then shut off the ignition. If it's necessary to do so, take out the air bag according to the correct safety instructions. Then, take away the bottom screw and set the steering wheel to pointed at 6:00 before removing the two back screws on the speed control switch. Separate the wires from the connector and take away the switch. When installing, secure the switch with the rubber seal in place, tighten the electrical connector and fasten the screws so that each is at 15 in. lbs. air bag should be put back, the negative
Battery Cable reconnected, after that, add the air cleaner lid as well as the inlet air temperature sensor and makeup air hose.