OEM Dodge Nitro Intake Valve

Dodge Nitro Intake Valve Parts and Q&A

• Intake Valve
  53020747AB
  Q: How to Remove and Replace Exhaust Valve and Intake Valves on Dodge Nitro?

  A:

  Lubricate the valve with clean engine oil and then put it carefully into the cylinder head. You should then install the Valve Stem Seal and check that everything is fully placed and the spring is intact. After that, place the spring and the spring retainer into position. After compressing the spring with the spring compressor, insert each retainer half for the valves into the engine. Make certain that the valve retainer halves are fully seated in the valve as well as the spring retainer rod before continuing. With a clean engine oil, grease the Camshaft journal and make certain the left sprocket dowel is at 11 o'clock and the right dowel at 12 o'clock while the camshaft is in place. Insert the retaining bolts for the camshaft bearing cap, tighten them with a torque wrench to 9-13 Nm (100 in. lbs.) one-half turn at a time in the right order. After that, carefully position both the hydraulic lash adjusters and Rocker Arms.
• Intake Valve
  4663836
  Q: How to Install Exhaust Valve and Intake Valves on Dodge Nitro?

  A:

  Before inserting, lubricate the valve stem with clean engine oil and set it in the head of the cylinder. After that, insert the Valve Stem Seal and make sure it snaps in place, with the garter spring still intact. Following that, add in the spring and secure the spring retainer. Place the coiled valve spring onto the compressor, compress the spring and add the two retainer halves. When the valve spring compressor is released, verify that the retainer seats securely onto each of the two spring retainers. Give the Camshaft journals a coating of clean oil, make sure the camshaft connector plates are at 11 and 12 o'clock on their respective cylinders and fix the caps in place. Tighten the camshaft bearing cap retaining bolts to 9-13 Nm (100 in. lbs.) an additional 1/2 turn for each bolt, always in their right sequence. Now, secure the hydraulic lash adjusters along with the Rocker Arms.