OEM Dodge Stratus Throttle Cable

Dodge Stratus Throttle Cable Parts and Q&A

• Throttle Cable
  4591667AD
  Q: How to Service and Repair a Throttle Cable on Dodge Stratus?

  A:

  Getting access to the throttle cable begins with holding the throttle body throttle lever all the way open from the engine area. Unlock the throttle cable from the throttle body cam and proceed to open the vehicle to remove the retainer at the top end of the pedal lever. Then, unclip the clip at the end of the throttle cable from the throttle cable grommet at the dash, pull the cable out of the dash and remove the cable grommet from the dash panel. Compress the throttle bracket holding the ears together and slowly remove the cable by pulling it free. On a 4 cylinder engine, pull the throttle cable out from the routing clip on the Fuel Rail, as well as the routing clip on the left front shocktower. When installing, feed the pedal end fitting through the dash opening from the engine side, seat the grommet and fit the cable dash fitting into the grommet. On the engine, link the throttle body end-fitting to the cable mounting bracket and then on 4 cylinder engines attach the throttle cable routing clip to the bracket on the fuel rail and the additional clip to the shocktower. From inside, press the pedal to the floor and fasten the throttle cable and retainer on top of the lever. Berigate the cable retainer clip behind the throttle cable fitting that's attached to the dash and place it under the grommet. Turn the throttle lever to its widest position from the engine compartment and fix the throttle cable.
• Throttle Cable
  MR297586
  Q: How to Maintain and Fix a Throttle Cable on Dodge Stratus?

  A:

  Start by opening the Throttle Body lever from the engine compartment all the way. Go inside the car, hold the throttle pedal up, separate the retainer and the cable from the top of the lever. Afterward, get rid of the clip near the throttle and at the dash panel, then pull the throttle cable straight out of the panel. Compress one retaining ear on each saddle and pull the throttle cable from the bracket, followed by the basket. Also, take out the throttle cable from its clips on the fuel rail and the left front shock tower on 4 cylinder engines. The first step for installation is to install the throttle body, then secure it in place with bolts that have torque of 13.6 Nm (120 in. lbs.). After that, install the throttle cable bracket and tighten its bolts to 14.1 Nm (125 in. lbs). When setting up the throttle and speed control cables, hold the throttle lever at full open so the cables are properly installed. After that, connect the idle air motor and TPS to the electrical connectors and secure the shield to the throttle cable.