Pry up the speaker cover at its service notch using an approved flat blade. Following that, open the four screws keeping the speaker attached, disconnect the wire and take the speaker off the door panel. Start by cutting off the battery negative cable, then take away the instrument panel upper cover. Once the wire harness is out, remove both retaining screws from the speakers, pull out the speaker and unplug the wire harness connector. Again, unconnect the negative
Battery Cable, remove the fasteners of the speaker enclosure and pull out the electrical harness connector before you take the speaker out. Unplug and remove the area where your battery negative cable is connected and then remove the right quarter trim panel for the rear subwoofer. Afterward, eliminate the basteners for mounting the subwoofer, separate the harness connector from the speaker and then unplug the speaker.