You must first unbolt the rear brake shoes to take out the cross-member. After that, detach the park brake cable from the lever. With the hair pin clip removed, take out the brake cable from its place at the backing plate. After that, undo the bolt and release the
Brake Line from the
Trailing Arm. After that, remove another bolt, the clip and cut the brake line from the trailing arm. Place the wheel speed sensors out of the way so that you can take out the crossmembers. Should you need to, take out the rear drive module. Get rid of all the cotter pins, nuts and washers and separate the two half shafts. Then, take out both lower strut bolts and trailing link bushing bolts. With the car up on jacks, secure the rear cradle beneath (using a suitable lifting tool) and loosen and take out the rear cradle bolts. At this stage, take out the nuts on the lower stabilizer links, remove the bolts on the lower and upper links at the cradle and unbolt the toe link cams from the cradle. Finally, remove the suspension knuckle assemblies and the stabilizer bushing bolts to separate the stabilizer bar from the cradle.