OEM 2000 Dodge Neon Camshaft Position Sensor

2000 Dodge Neon Camshaft Position Sensor Parts and Q&A

• Q: How to Remove and Install a Camshaft Position Sensor on 2000 Dodge Neon?

  A: You will find the Camshaft Position Sensor positioned at the rear of the cylinder head. The first thing to do is to move the brake booster hose and electrical connector out of their holders on the end of the cylinder head cover. The following step is to remove the electrical connectors from the Camshaft Position Sensor, then loosen the holding screws to take the sensor out. To access the target magnet, use the screw on the back of the camshaft to free up the mounting. Place the magnet into the spot where the machined locating holes end and tighten the connecting screw to 3.4 Nm (30 in. lbs.) torque. After that, connect the Camshaft Position Sensor and tighten its screws to an amount of 9 Nm (80 in. lbs.) torque. At last, connect the brake booster hose and electrical wires to their holders on the end of the valve cover and put the electrical connectors onto the Camshaft Position Sensor.