Other Name: Module - Anti-Lock Brake; ABS Control Module; Hydraulic Unit; Control Unit Anti-Lock Brake
Replaces: 52010072AE
Item Weight: 9.50 Pounds
Item Dimensions: 9.5 x 9.2 x 9.6 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 52010072AF
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2000 Dodge Ram 2500 Submodels:
Base | 10 Cyl 8.0 L GAS, 6 Cyl 5.9 L DIESEL, 8 Cyl 5.9 L GAS
2000 Dodge Ram 2500 ABS Control Module Parts and Q&A
Q: How to Service and Repair the ABS Control Module for a Four-Wheel Antilock System on 2000 Dodge Ram 2500?
A: The first thing to do to work on the Four Wheel Antilock System's Controller Antilock Brake unit is to disconnect the negative cable for the battery. Open up the harness connector locks and take out the connectors from the CAB, then separate the pump motor's harness connector. Unscrew the CAB from the HCU such that you can remove it from the case. Be sure the seal from the CAB is positioned correctly on the HCU before installing it. Put in the mounting screws, then tighten them to 4 - 4.7 Nm (36 - 42 inch lbs.). After that, join the pump motor harness to the plane's system, attach both harnesses to the CAB and ensure the connections are secure. Afterwards, put the battery back into the vehicle. If the CAB gets replaced, set both the rear axle type and tire revolutions per mile in the new CAB after you get the axle type from the Differential and revolutions from Tires, Wheels and Alignment.