How to Replace and Reinstall an Ignition Coil on 2000 Jeep Cherokee?

The ignition coil should be replaced with an equivalent type stuffed with epoxy if removed. Disconnect the secondary cable and engine harness then remove the mounting bolts. Install a new coil and tighten to 11 Nm for nuts/bolts or 5 Nm for bolts only. Reconnect the harness and ignition coil cable.

OEM 2000 Jeep Cherokee Ignition Coil

Ignition Coil Resistor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Ignition Coils found

View related parts
2000 Jeep Cherokee Ignition Coil Part Number: 56028172AC
$74.65 MSRP: $115.00
You Save: $40.35 (36%)
ADD TO CART
Product Specifications
- Other Name: Coil/Ignition - Ignition; Coil
- Replaces: 56028172AB
- Item Weight: 1.40 Pounds
- Item Dimensions: 2.9 x 4.2 x 4.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56028172AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Jeep Cherokee Submodels:
- Classic, Limited, SE, Sport | 4 Cyl 2.5 L GAS, 6 Cyl 4.0 L GAS
View related parts
2000 Jeep Cherokee Ignition Coil Part Number: 56041476AB
Product Specifications
- Other Name: Coil/Ignition - Ignition; Direct Ignition Coil
- Replaces: 56041476AA
- Item Weight: 4.70 Pounds
- Item Dimensions: 5.3 x 6.2 x 29.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56041476AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Jeep Cherokee Submodels:
- Classic, Limited, SE, Sport | 4 Cyl 2.5 L GAS, 4.0L V6, 6 Cyl 4.0 L GAS

2000 Jeep Cherokee Ignition Coil Parts and Q&A

Q: How to Replace and Reinstall an Ignition Coil on 2000 Jeep Cherokee?
A: The ignition coil should be replaced with an equivalent type stuffed with epoxy if removed. Disconnect the secondary cable and engine harness then remove the mounting bolts. Install a new coil and tighten to 11 Nm for nuts/bolts or 5 Nm for bolts only. Reconnect the harness and ignition coil cable.