How to Remove and Install an Intake Manifold Temperature Sensor on 2000 Jeep Grand Cherokee?

It is standard to see the Intake Manifold Temperature (IMT) sensor in the area of the intake manifold plenum close to the front of the throttle body. To begin, unplug the sensor's electrical connection and after that, remove the sensor from the intake manifold. Put the sensor inside the intake manifold, tighten it to 28 Nm (20 ft. lbs.) and then attach the electrical connector to the sensor again.

OEM 2000 Jeep Grand Cherokee Intake Manifold Temperature Sensor

Air Intake Temperature Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Intake Manifold Temperature Sensor found

View related parts
2000 Jeep Grand Cherokee Air Temperature Sensor Part Number: 56027872
$38.87 MSRP: $57.85
You Save: $18.98 (33%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Air Temperature; Engine Intake Manifold Temperature Sensor; Intake Air Temperature Sensor; Air Intake Temperature Sensor; Temperature Sending Unit; Sensor Ambient Temperature; Sensor Air Temperature
- Item Weight: 0.50 Pounds
- Item Dimensions: 3.9 x 2.6 x 1.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56027872
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Jeep Grand Cherokee Submodels:
- 5.9 Limited, Laredo, Limited, Orvis, Special Edition, Sport, TSi | 6 Cyl 4.0 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS

2000 Jeep Grand Cherokee Intake Manifold Temperature Sensor Parts and Q&A

Q: How to Remove and Install an Intake Manifold Temperature Sensor on 2000 Jeep Grand Cherokee?
A: It is standard to see the Intake Manifold Temperature (IMT) sensor in the area of the intake manifold plenum close to the front of the throttle body. To begin, unplug the sensor's electrical connection and after that, remove the sensor from the intake manifold. Put the sensor inside the intake manifold, tighten it to 28 Nm (20 ft. lbs.) and then attach the electrical connector to the sensor again.