How to service the front wheel speed sensor on 2001 Dodge Ram 3500 Van?

First, raise and hold up the vehicle to start working on the front wheel speed sensor. Loosen the sensor from the steering knuckle by removing its fastener from the harness, then take the sensor out. The sensor should only be joined to the car using a factory replacement bolt. Set the sensor in the steering knuckle, fasten it with the bolt to 15 Nm (11 ft. lbs.), then attach the sensor wire to the main harness and be sure to avoid hot or moving parts. Take off the supports and bring the vehicle down to the ground.

OEM 2001 Dodge Ram 3500 Van Speed Sensor

Speed Control Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Speed Sensor found

View related parts
2001 Dodge Ram 3500 Van ABS Sensor, Rear Part Number: 56028187AE
$64.56 MSRP: $96.75
You Save: $32.19 (34%)
ADD TO CART
Product Specifications
- Other Name: Sensor - Wheel Speed; ABS Wheel Speed Sensor, Rear; Vehicle Speed Sensor; Speed Sensor; Rear Speed Sensor; Sensor Wheel Speed; ABS Wheel Speed Sensor
- Position: Rear
- Replaces: 56028187AD
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.9 x 2.6 x 3.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56028187AE
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2001 Dodge Ram 3500 Van Submodels:
- Base | 8 Cyl 5.2 L CNG, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS

2001 Dodge Ram 3500 Van Speed Sensor Parts and Q&A

Q: How to service the front wheel speed sensor on 2001 Dodge Ram 3500 Van?
A: First, raise and hold up the vehicle to start working on the front wheel speed sensor. Loosen the sensor from the steering knuckle by removing its fastener from the harness, then take the sensor out. The sensor should only be joined to the car using a factory replacement bolt. Set the sensor in the steering knuckle, fasten it with the bolt to 15 Nm (11 ft. lbs.), then attach the sensor wire to the main harness and be sure to avoid hot or moving parts. Take off the supports and bring the vehicle down to the ground.