How to Service and Repair a Steering Knuckle on 2001 Jeep Cherokee?

To service the steering knuckle, remove the hub bearing and axle shaft. For the ball studs, use Tool Kit 6289. Disconnect tie-rod, remove cotter pins and nuts and then strike knuckle to loosen it. Reinstall by tightening up the nuts and reconnecting components.

OEM 2001 Jeep Cherokee Steering Knuckle

Front Steering Knuckle

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Steering Knuckles found

View related parts
2001 Jeep Cherokee Spindle Assembly, Front Driver Side Part Number: 52067577
Product Specifications
- Other Name: Knuckle - Front; Steering Knuckle, Front Left; Spindle; Knuckle; Knuckle, Steering 1991, Right; Knuckle, Steering, Right; Knuckle, Steering; Knuckle Front
- Position: Front Driver Side
- Item Weight: 8.20 Pounds
- Item Dimensions: 12.2 x 12.1 x 6.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52067577
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2001 Jeep Cherokee Submodels:
- Base, Briarwood, Classic, Country, Laredo, Limited, SE, Sport | 4 Cyl 2.5 L GAS, 6 Cyl 4.0 L GAS
View related parts
2001 Jeep Cherokee Spindle Assembly, Front Passenger Side Part Number: 52067576
Product Specifications
- Other Name: Knuckle - Front; Steering Knuckle, Front Right; A/C Compressor Cut-Out Switch; HVAC Pressure & Trinary Switch.; Axle Housing; Lower Pressure Cut-Off Switch; Spindle; Right Steering Knuckle; Front Knuckle
- Position: Front Passenger Side
- Item Weight: 11.80 Pounds
- Item Dimensions: 11.9 x 9.8 x 4.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52067576
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2001 Jeep Cherokee Submodels:
- Base, Briarwood, Classic, Country, Laredo, Limited, SE, Sport | 4 Cyl 2.5 L GAS, 6 Cyl 4.0 L GAS

2001 Jeep Cherokee Steering Knuckle Parts and Q&A

Q: How to Service and Repair a Steering Knuckle on 2001 Jeep Cherokee?
A: To service the steering knuckle, remove the hub bearing and axle shaft. For the ball studs, use Tool Kit 6289. Disconnect tie-rod, remove cotter pins and nuts and then strike knuckle to loosen it. Reinstall by tightening up the nuts and reconnecting components.