Other Name: Seat Belt - Seat Belt Timer; Module; Module Seat Belt Timer
Item Weight: 1.40 Pounds
Item Dimensions: 13.4 x 11.7 x 2.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 4671300AB
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2002 Chrysler Sebring Submodels:
Base, GTC, JX, JXi, LX, LXi, Limited, Touring | 4 Cyl 2.4 L GAS, 6 Cyl 2.5 L GAS, 6 Cyl 2.7 L FLEX, 6 Cyl 2.7 L GAS
| Page 1 of 4 |Next >
1-20 of 63 Results
2002 Chrysler Sebring Seat Belt Parts and Q&A
Q: How to Maintain Your Front Seat Belt and Retractor on 2002 Chrysler Sebring?
A: Before servicing the front seat seat belt and retractor, remove the negative battery cable and isolate it. Unscrew the knob and removal loop cover, next release the bolt fastening the turning loop to the height adjuster. Remove both B-pillar panels on the door frame and disconnect the wire harness connector from the B-pillar retractor afterward. Return the bolt that holds the seat belt retractor and lower anchor onto the floor at the base of the B-pillar and then unhook the belt and retractor from the vehicle. Fit the retractor and belt underneath the seat and attach the bolt securing the retractor and lower anchor to the base of the B-pillar using 55 ± 5 Nm (40.5 ft. lbs.). The retractor wire harness connector goes on the B-pillar, the belt should be routed and the lower B-pillar trim panel can be installed. Put the plastic B-pillar covering in place, followed by the bolt to the turning loop on the height adjustment and tighten it to 55 ± 5 Nm (40.5 ft. lbs.). Now, place the turning loop cover on top and attach the adjustment knob, before reconnecting the battery negative terminal.