Other Name: Switch - Power Seat; Power Seat Switch, Front, Front Left; Switch Assembly; Seat Switch; Adjust Handle; Switch; Switch Power Seat; Power Seat Switch
Position: Front
Replaces: 4373666
Item Weight: 0.60 Pounds
Item Dimensions: 2.9 x 3.9 x 3.9 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 56049777AA
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2002 Jeep Grand Cherokee Submodels:
Base, Laredo, Limited, Orvis, Overland, SE, Special Edition, Sport | 4.0L L6, 4.7L V8, 6 Cyl 4.0 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, EKY
Other Name: Switch - Power Seat; Power Seat Switch, Front Left, Left; Power Seat Switch; Switch Assembly; Seat Switch; Adjust Handle; Adjuster Switch; Switch
Position: Driver Side
Replaces: 4601757AB, 5191951AA
Item Weight: 0.80 Pounds
Item Dimensions: 5.6 x 4.2 x 3.1 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 4601757AC
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2002 Jeep Grand Cherokee Submodels:
5.9 Limited, Laredo, Limited, Orvis, Overland, Special Edition, Sport, TSi | 4.0L L6, 4.7L V8, 6 Cyl 4.0 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2002 Jeep Grand Cherokee Submodels:
Laredo, Limited, Overland, Special Edition, Sport | 6 Cyl 4.0 L GAS, 8 Cyl 4.7 L GAS
2002 Jeep Grand Cherokee Seat Switch Parts and Q&A
Q: How to Perform a Seat Switch on 2002 Jeep Grand Cherokee?
A: You should disconnect and separate the negative battery cable before replacing the memory set switch. Afterward, remove the front door trim from the driver's side. Take out the wire harness connector of the memory switch from the driver door module connector. Release the memory switch by unscrewing the two holders in the back of the door panel and pulling it out. On the back of the driver's front door trim panel, set the new switch in position and tighten the two screws to 2.2 Nm (20 in. lbs.). Reattach the memory switch wire harness connector to the driver door module connector and afterward, mount the trim panel onto the front driver's door. At the end, link the black battery cable back to the negative terminal.