OEM 2003 Chrysler PT Cruiser Ignition Coil

2003 Chrysler PT Cruiser Ignition Coil Parts and Q&A

• Q: How to Replace an Ignition Coil on 2003 Chrysler PT Cruiser?

  A: Release the negative battery cable and then take the shield off the throttle control. After that, separate the throttle cables from the throttle body lever and remove the bracket, placing it where it should go. Remove the spark plug cables from the ignition coil and open the electrical connector to pull it out. Disconnect the vehicle's ignition coil by first taking off the two upper bolts on its side with a wrench, then fully remove it by pulling up and separating it from the throttle body side of the intake manifold. Set the coil on the throttle body end of the intake manifold and turn it down toward the valve cover. Fasten the electrical connector to the ignition coil and then install the bolts, tightening down just two of the bolts after the coil is in position. Insert the spark plug cables into place on the ignition coil, then connect the throttle cable bracket and the throttle cables onto the throttle body lever. Reinstall the throttle control shield and join the wire from the negative battery to the body, avoiding contact between the ignition cables and the throttle body and its accessories.