Other Name: Blade - Front Wiper; Windshield Wiper Blade, Left; Front Blade; Blade Front Wiper; Blade Wiper
Position: Front Driver Side
Item Weight: 1.50 Pounds
Item Dimensions: 27.0 x 1.8 x 0.8 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 5135561AA
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2007 Dodge Durango Submodels:
Adventurer, Limited, Limited Hybrid, SE, SLT, ST, SXT | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 5.7 L GAS
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2007 Dodge Durango Submodels:
Adventurer, Limited, Limited Hybrid, SE, SLT, ST, SXT | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 5.7 L GAS
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2007 Dodge Durango Submodels:
Adventurer, Limited, Limited Hybrid, SE, SLT, SXT | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 5.7 L GAS
Other Name: Blade - Front Wiper; Windshield Wiper Blade, Right; Front Blade; Blade Front Wiper; Blade Wiper
Position: Front Passenger Side
Item Weight: 0.80 Pounds
Item Dimensions: 22.1 x 1.6 x 1.0 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 5135560AA
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2007 Dodge Durango Submodels:
Adventurer, Limited, SLT, ST, SXT | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS
2007 Dodge Durango Wiper Blade Parts and Q&A
Q: How to Replace a Rear Wiper Blade on 2007 Dodge Durango?
A: Before adding a new element, remove the old rear wiper blade from the unit. Use your hand to secure the wiper blade link at the center of the bar and use your other hand to hold both the wiper element and the flexor at the same point just before the claws for that link. Pull the element and flexor out of the connection to where they flex enough, then slide them to the empty end to release from the remaining sets of claws. To add a new element and flexors, repeat the original steps in reverse and fit the wiper blade onto the wiper arm again.