Other Name: Pump - Washer, Windshield; Windshield Washer Pump; Washer Pump Repair Kit; Front Pump; Front Washer Pump; Rear Washer Pump; Pump Windshield Washer Dual Outlet; Pump Washer, Windshield
Replaces: 5179153AB, 5179153AA
Item Weight: 0.70 Pounds
Item Dimensions: 2.6 x 3.5 x 3.8 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 5179153AC
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2007 Dodge Nitro Submodels:
Detonator, Heat, R/T, SE, SLT, SXT, Shock | 3.7L V6, 4.0L V6, 6 Cyl 3.7 L GAS, 6 Cyl 4.0 L GAS
2007 Dodge Nitro Washer Pump Parts and Q&A
Q: How to Maintain Your Washer Pump on 2007 Dodge Nitro?
A: The first thing to do is disconnect and separate the negative cable of the battery before proceeding. Pour the washer fluid from the washer reservoir - on the left of the cooling module inside the engine compartment - into a clean container you can use again. After that, pull off the front end module wire harness connector (3) from the top of the motor housings' washer pump/motor unit connector receptacle (2). Take the two washer hoses (4 and 5) away from the washer pump/motor unit's outlet nipples. Hold the top edge of the washer pump/motor housing tightly and pull it out slightly from the reservoir; make sure not to accidently damage the reservoir at this point. Pull out the washer pump/motor up and away from the reservoir to remove the inlet nipple from the seal/filter screen it is connected to inside the washer. Next, take out and dispose of the rubber grommet seal/filter screen covering the pump mounting hole in the washer's reservoir.