How to Service and Repair a Driveshaft Center Support Bearing on 2007 Dodge Ram 3500?

Begin by taking off the rear propeller shaft to work on the driveshaft center support bearing. Place marks for alignment on the rear and front shafts. After that, take off the slip joint boot clamp. Loosen the boot from the boot collar at the top and open up the shafts. Insert the Position Bearing Splitter Tool 1130 between the propeller shaft and driveshaft center support bearing. In the last step, set Bridge 938 into position on the splitter and remove the middle bearing.

OEM 2007 Dodge Ram 3500 Driveshaft Center Support Bearing

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Driveshaft Center Support Bearing found

View related parts
2007 Dodge Ram 3500 Center Bearing Part Number: 5183094AC
$158.33 MSRP: $242.00
You Save: $83.67 (35%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Bearing - Drive Shaft; Driveshaft Center Support Bearing; Bearing Kit Drive Shaft
- Replaces: 5183094AB, 5183094AA
- Item Weight: 4.20 Pounds
- Item Dimensions: 8.2 x 8.2 x 4.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5183094AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Dodge Ram 3500 Submodels:
- Laramie, SLT, ST, SXT, Sport | 5.7L V8, 5.9L L6, 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL, 6.7L L6, 8 Cyl 5.7 L GAS

2007 Dodge Ram 3500 Driveshaft Center Support Bearing Parts and Q&A

Q: How to Service and Repair a Driveshaft Center Support Bearing on 2007 Dodge Ram 3500?
A: Begin by taking off the rear propeller shaft to work on the driveshaft center support bearing. Place marks for alignment on the rear and front shafts. After that, take off the slip joint boot clamp. Loosen the boot from the boot collar at the top and open up the shafts. Insert the Position Bearing Splitter Tool 1130 between the propeller shaft and driveshaft center support bearing. In the last step, set Bridge 938 into position on the splitter and remove the middle bearing.