How to Install a Driveshaft Center Support Bearing on 2007 Dodge Sprinter 2500?

Installation of the driveshaft center support bearing- Press the propeller shaft with installer 9275. Installation and tightening of a new bolt to 95 Nm should be installed in case it has a round flange. Before installing the propeller shaft, install the snap-ring, grease the spline, connect the rubber boot, match markings and fix with collar clamps.

OEM 2007 Dodge Sprinter 2500 Driveshaft Center Support Bearing

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Driveshaft Center Support Bearings found

View related parts
2007 Dodge Sprinter 2500 Center Bearing Part Number: 68031835AA
Product Specifications
- Other Name: Bearing - Drive Shaft; Driveshaft Center Support Bearing
- Replaces: 68006649AA
- Item Weight: 3.00 Pounds
- Item Dimensions: 11.7 x 6.9 x 3.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68031835AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Dodge Sprinter 2500 Submodels:
- Base | 3.0L V6, 3.5L V6, 6 Cyl 3.0 L DIESEL, 6 Cyl 3.5 L GAS
View related parts
2007 Dodge Sprinter 2500 Center Bearing Part Number: 68031836AA
Product Specifications
- Other Name: Bearing - Drive Shaft; Drive Shaft Center Support Bearing; Driveshaft Center Support Bearing; Center Bearing Drive Shaft
- Item Weight: 2.60 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68031836AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2007 Dodge Sprinter 2500 Submodels:
- Base | 6 Cyl 3.0 L DIESEL, 6 Cyl 3.5 L GAS

2007 Dodge Sprinter 2500 Driveshaft Center Support Bearing Parts and Q&A

Q: How to Install a Driveshaft Center Support Bearing on 2007 Dodge Sprinter 2500?
A: Installation of the driveshaft center support bearing- Press the propeller shaft with installer 9275. Installation and tightening of a new bolt to 95 Nm should be installed in case it has a round flange. Before installing the propeller shaft, install the snap-ring, grease the spline, connect the rubber boot, match markings and fix with collar clamps.