How to Service and Repair a Yaw Sensor on 2007 Jeep Patriot?

Before working on the Yaw Rate Sensor, detach and isolate the battery negative cable from the battery post. Following that, open up the shifter housing center console by removing it. After that, take out the wiring harness plug at the dynamics sensor. Afterwards, take out the nuts that hold the dynamics sensor to the floor pan tunnel. Furthermore, take out the dynamics sensor.

OEM 2007 Jeep Patriot Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Yaw Sensors found

View related parts
2007 Jeep Patriot Yaw Rate Sensor Part Number: 5033322AC
Product Specifications
- Other Name: Module - Electronic Stability; Control Module; Stab Control Module; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 4.10 Pounds
- Item Dimensions: 10.5 x 6.3 x 6.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033322AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Patriot Submodels:
- Limited, Sport | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS
View related parts
2007 Jeep Patriot Stab Control Module Part Number: 5033321AC
Product Specifications
- Other Name: Module - Electronic Stability; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 1.90 Pounds
- Item Dimensions: 14.8 x 9.7 x 3.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033321AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Patriot Submodels:
- Limited, Sport | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS

2007 Jeep Patriot Yaw Sensor Parts and Q&A

Q: How to Service and Repair a Yaw Sensor on 2007 Jeep Patriot?
A: Before working on the Yaw Rate Sensor, detach and isolate the battery negative cable from the battery post. Following that, open up the shifter housing center console by removing it. After that, take out the wiring harness plug at the dynamics sensor. Afterwards, take out the nuts that hold the dynamics sensor to the floor pan tunnel. Furthermore, take out the dynamics sensor.