How to Install a Yaw Sensor on 2008 Jeep Patriot?

Lift the dynamics sensor over the studs attached to the floor pan tunnel and fix it in place by tightening the two nuts to 9 Nm (80 in. lbs.). After that, attach the wiring harness connector to the dynamics sensor. After that, put in the shifter housing center console. Place the negative terminal of the battery cable on the corresponding post of the battery. After testing, go ahead with the Verification Test and end the clearing of faults.

OEM 2008 Jeep Patriot Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Yaw Sensors found

View related parts
2008 Jeep Patriot Yaw Rate Sensor Part Number: 5033322AC
Product Specifications
- Other Name: Module - Electronic Stability; Control Module; Stab Control Module; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 4.10 Pounds
- Item Dimensions: 10.5 x 6.3 x 6.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033322AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Jeep Patriot Submodels:
- Limited, Sport | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS
View related parts
2008 Jeep Patriot Stab Control Module Part Number: 5033321AC
Product Specifications
- Other Name: Module - Electronic Stability; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 1.90 Pounds
- Item Dimensions: 14.8 x 9.7 x 3.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033321AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Jeep Patriot Submodels:
- Limited, Sport | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS

2008 Jeep Patriot Yaw Sensor Parts and Q&A

Q: How to Install a Yaw Sensor on 2008 Jeep Patriot?
A: Lift the dynamics sensor over the studs attached to the floor pan tunnel and fix it in place by tightening the two nuts to 9 Nm (80 in. lbs.). After that, attach the wiring harness connector to the dynamics sensor. After that, put in the shifter housing center console. Place the negative terminal of the battery cable on the corresponding post of the battery. After testing, go ahead with the Verification Test and end the clearing of faults.