How to Remove the ABS Control Module on 2008 Chrysler Crossfire?

First, detach the negative battery cable and then clean the top area of your Hydraulic Control Unit before replacing the Electronic Brake Control Module. Mark where the hydraulic brake lines are connected to the HCU so you can easily put them back in place before you remove the lines (1-6) from the HCU and cap each one with a plug. After that, take off the Controller Antilock Brake (CAB) harness connector. Remove the ICU retaining screws and, while doing so, push the hydraulic brake lines on both sides. In the last step, loosen and remove the retaining screws connecting the CAB to the HCU and carefully take the CAB apart from the HCU.

OEM 2008 Chrysler Crossfire ABS Control Module

Anti Lock Brake Control Module

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 ABS Control Modules found

View related parts
2008 Chrysler Crossfire Modulator Valve Part Number: 5161126AB
Product Specifications
- Other Name: Control - Anti-Lock Brake System; ABS Hydraulic Assembly; ABS Control Module; ABS Control Unit; Hydraulic Control Unit Anti-Lock Brake System
- Item Weight: 7.50 Pounds
- Item Dimensions: 12.2 x 7.9 x 7.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5161126AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Chrysler Crossfire Submodels:
- Base, Limited, SRT-6 | 6 Cyl 3.2 L GAS
View related parts
2008 Chrysler Crossfire Control Module Part Number: 5161125AB
Product Specifications
- Other Name: Control - Anti-Lock Brake; ABS Control Module; Control Unit Anti-Lock Brake
- Replaces: 5135427AA, 5161125AA
- Item Weight: 2.50 Pounds
- Item Dimensions: 10.3 x 8.0 x 5.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5161125AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Chrysler Crossfire Submodels:
- Base, Limited, SRT-6 | 6 Cyl 3.2 L GAS

2008 Chrysler Crossfire ABS Control Module Parts and Q&A

Q: How to Remove the ABS Control Module on 2008 Chrysler Crossfire?
A: First, detach the negative battery cable and then clean the top area of your Hydraulic Control Unit before replacing the Electronic Brake Control Module. Mark where the hydraulic brake lines are connected to the HCU so you can easily put them back in place before you remove the lines (1-6) from the HCU and cap each one with a plug. After that, take off the Controller Antilock Brake (CAB) harness connector. Remove the ICU retaining screws and, while doing so, push the hydraulic brake lines on both sides. In the last step, loosen and remove the retaining screws connecting the CAB to the HCU and carefully take the CAB apart from the HCU.