OEM 2008 Chrysler Crossfire Valve Stem Seal

2008 Chrysler Crossfire Valve Stem Seal Parts and Q&A

• Q: How to Install Valve Stem Seals on 2008 Chrysler Crossfire?

  A: Burred or nicked valve stems should first be replaced before putting in the valve stem seals. Start by treating the fresh seal with clean engine oil. After that, put the sleeve on the valve stem and, using the seal pliers, press the new seal onto the stem. Once this part is done, remove the protective covering. After putting in the valve spring seat, spring and retainer, use the assembly tool to compress the valve spring. After compressing the valve spring, set the valve stem collets in place, give the valve spring room to relax and verify that the collets are sitting properly in the valve spring retainer before taking out the assembly tool. It's necessary to work on just one cylinder, then repeat for other valves that you want to maintain. Once Special Tool 9102 Flywheel Locking Tool is out, move on to fit the starter and camshafts in your system.