How to Service a Brake Light Switch on 2008 Jeep Wrangler?

First, you must turn off the Supplemental Restraint System (SRS) by removing the negative cable from the battery, waiting two minutes and reconnecting it so the system capacitor empties. Begin removal by taking off the panel above the steering wheel. After depressing the brake pedal, turn the brake lamp switch housing counterclockwise by about 30 degrees so that the tabs of the switch locking collar fit into the keyed hole on the brake lamp switch bracket. Twist the keyed handle backward, pull it out and give the brake pedal a light press to make sure it isn't holding you back. Lastly, take out the connector at the brake lamp switch.

OEM 2008 Jeep Wrangler Brake Light Switch

Brake Lamp Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Brake Light Switch found

View related parts
2008 Jeep Wrangler Brake Switch Part Number: 4671336AD
$39.68 MSRP: $53.75
You Save: $14.07 (27%)
ADD TO CART
Product Specifications
- Other Name: Switch - Stop Lamp; Brake Light Switch; Stop Light Switch; Brake Pedal Switch; Lamp Switch; Release Switch; Stoplamp Switch; Switch; Switch Stop Lamp
- Replaces: 4671336, 4671336AC, 4671336AB
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.6 x 2.0 x 3.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4671336AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Jeep Wrangler Submodels:
- 65th Anniversary Edition, 70th Anniversary, 75th Anniversary, Rubicon, SE, Sahara, Sport, Sport S, Unlimited, Unlimited 70th Anniversary, Unlimited 75th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited Sport S, Unlimited X, X | 3.6L V6, 3.8L V6, 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS

2008 Jeep Wrangler Brake Light Switch Parts and Q&A

Q: How to Service a Brake Light Switch on 2008 Jeep Wrangler?
A: First, you must turn off the Supplemental Restraint System (SRS) by removing the negative cable from the battery, waiting two minutes and reconnecting it so the system capacitor empties. Begin removal by taking off the panel above the steering wheel. After depressing the brake pedal, turn the brake lamp switch housing counterclockwise by about 30 degrees so that the tabs of the switch locking collar fit into the keyed hole on the brake lamp switch bracket. Twist the keyed handle backward, pull it out and give the brake pedal a light press to make sure it isn't holding you back. Lastly, take out the connector at the brake lamp switch.