How to Install a Spoiler on 2009 Dodge Caliber?

Question

Accepted Answer

The first step for installing a non Srt 4 spoiler is to connect the car's satellite wire attachment. Attach the new seal and link the Chmsl wire when needed. Wipe the ends of the liftgate with alcohol and remove the tape from each foam spacer on the spoiler's ends so they are ready to place. Place the spoiler on top of the vehicle, push the center push pin through the center hole in the liftgate and attach four spoiler nuts to the spoiler studs. Attach the spoilers socks and push the spoiler into place above the spacers to glue the tape onto the liftgate and finally add the upper liftgate molding. On the Srt 4, join the satellite wire connector with the washer hose onto the washer nozzle. Put the electrical connector on the center high mount stop lamp and plug the wire back into the clip on the spoiler. Carefully clean up all the surface areas on the liftgate where the adhesive patch is placed before you remove the second set of cover stickers and press down the spoiler onto the cleaned areas. Guide four nuts onto the spoiler studs before fitting the body plugs and the liftgate upper molding.

OEM 2009 Dodge Caliber Spoiler

2 Spoilers found

2009 Dodge Caliber Spoiler, Rear Part Number: YQ84RXFAM

2009 Dodge Caliber Spoiler, Rear Part Number: 1HR28ZZZAA

2009 Dodge Caliber Spoiler Parts and Q&A

Related 2009 Dodge Caliber Parts

Alternate Year Models