OEM Chrysler Crossfire Antenna

Chrysler Crossfire Antenna Parts and Q&A

• Antenna Base
  5161959AB
  Q: How to Safely Remove and Replace a Radio Antenna While Ensuring Proper Urethane Adhesive Curing on Chrysler Crossfire?

  A:

  If the rear window glass was installed in the last 24 hours, put off replacing the radio antenna; also check the expiration date of the adhesive and refer to the urethane manufacturing instructions. Before installing the rear window, open the door glass to prevent the interior from getting too filled with air which can cause water to leak if a door is slammed before the urethane bonding is finished. The first action is to take out the negative battery cable, then take off the liftgate's interior trim panel. After that, take the center high mount stop lamp harness apart and remove the Chmsl from the liftgate. After that, you should remove the rear window defogger and rear window antenna harness connectors from the terminals before you take the liftgate glass out.
• Antenna Mast
  5104986AA
  Q: How to Install and Replace a Radio Antenna on a Liftgate on Chrysler Crossfire?

  A:

  Start by installing the liftgate glass when putting in the radio antenna. After that, plug the rear window defogger (3) and the rear window antenna (1) connectors into the liftgate glass terminals. After that, fit the Chmsl assembly to the liftgate (2) and attach the Chmsl harness connector. Then, fix the liftgate interior part and then link the negative battery connection.