OEM Chrysler Sebring Shift Cable

Chrysler Sebring Shift Cable Parts and Q&A

• Shift Control Cable
  5273214AG
  Q: How to Install and Adjust a Shift Cable Properly on Chrysler Sebring?

  A:

  Make sure the cable assembly fits in the floor pan hole first and put in the grommet (3) inside the hole using a bit of synthetic-based lubricant if needed for installation. After that, put the cable into its place in the retainer clip (2) and secure it to run the cable up to the transaxle shift lever. Position the car on lowered jack stands and, while attached, connect the cable to the bracket on the transaxle and to the transaxle shaft lever. Connect end (2) of the cable to portion (3) of the shifter conduit bracket and then place end (4) of the shift cable over the pin. Place the shift lever on the floor and the transaxle shift lever in Park before tightening the cable adjuster nut to 23 Nm (200 in. lbs.). Install the center console (1) and put on the gearshift bezel (2), then set the gearshift knob (1) on, tightening its set screw (2) practically as tight as you can by hand. In addition, confirm that the adjustment of the cables ensures the engine starter only works when the gear shift is in Park or Neutral.
• Shift Control Cable
  68105824AB
  Q: How to Remove the Shift Cable on Chrysler Sebring?

  A:

  The first step is to park the car, remove the negative cable from the left strut tower's battery and disconnect the shift cable. After that, uninstall the air cleaner assembly. Lift the cable above the manual valve lever with the pry tool and pull it off the lever. Once outside, take out the set screw from the gearshift knob and pull off the knob, bezel and range indicator lamp connector. Remove the center console assembly and unscrew the adjust lever. Pull the shifter cable core end loose from the shift lever pin using a pry tool and then push up on the cable clip from the bracket to remove the cable conduit. Use a hoist to lift the vehicle, then get rid of the cable grommet from near the floor pan. After completing the above, pull the cable out of the underbody by unfolding the retaining clip.