To put on the seat cover, place it over the foam and hold it in place with any hog rings needed. Before putting the cover and foam onto the seat back frame, you may need to slide the
Seat Belt under it through the seat cover. After that, install the seat cover clips to the back of the seat and then connect the seat back panel. Raise the 60 split seat and place the seat belt anchor bolt, then tighten it until the torque shows 49 N-m (36 ft. lbs.). First, pull the seat back up into its upright position and then put on the headrest guides and headrest. When installing the seat belt trim, place the folding seat handle next, fasten the mounting fasteners and top it off with covering the seat back.