OEM Dodge Magnum EGR Valve

Dodge Magnum EGR Valve Parts and Q&A

• EGR Valve
  4593892AA
  Q: How to Service and Repair the EGR Valve on a 2.7L Engine on Dodge Magnum?

  A:

  To work on the EGR valve in a 2.7L engine, first look for the EGR system's upper and lower tubes, as well as its valve. Remove the negative Battery Cable first and afterward unhook the purge solenoid from its mounting bracket and move it. Next, open and take out the electrical connector from the EGR valve. Now, remove the bolts that tie the EGR tube to the Exhaust Manifold, next, take out the bolts connecting the lower tube to the EGR valve and lastly take out the lower tube. Following this, unscrew the upper tube bolts fastened to the valve and take out the Hollinger valve's mounting bolts to remove it from the car. Never forget to clean the area where you are mounting after the speaker comes off.
• EGR Valve
  53032509AN
  Q: How to Install an EGR Valve on a 2.7L Engine on Dodge Magnum?

  A:

  The EGR valve should be installed on a 2.7L engine after the mounting surface is cleaned. After that, attach the EGR valve and fasten it with the bolts (1). Look at the seals around the opening of the EGR Tube at the Intake Manifold, position them correctly and ensure they aren't damaged before inserting the upper tube. Add a gasket to the junction between the EGR valve and upper tube and then screw in the bolts (2). Place the next, lower tube against the Exhaust Manifold, make sure to use a new gasket under the EGR valve and attach with bolts (3). Apply 15 Nm (11 ft. lbs.) of torque to the lower tube to EGR valve bolts and 31 Nm (23 ft. lbs.) torque to the bolts at the lower tube to exhaust manifold. Install bolts at the upper tube to the EGR valve (2) to 15 Nm (11 ft. lbs.) and the EGR valve bolts to the cylinder head (1) to 30 Nm (22 ft. lbs.). Attach the electrical connector to the EGR valve and hold it firm before moving on and putting the purge solenoid into its bracket. After that, reattach the negative battery connection and remove all stored DTC's with a diagnostic scan tool.