OEM 2000 Dodge Ram 1500 Van A/C Compressor Cut-Out Switches

HVAC Cut-Out Switch
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 A/C Compressor Cut-Out Switches found

  • 2000 Dodge Ram 1500 Van A/C Compressor Cut-Out Switches Diagram - 4897617AA
    View related parts
    Product Specifications
    • Other Name: Switch - A/C High Pressure Cut Off; HVAC Pressure Switch; A/C Compressor Cut-Out; Trinary Switch.; Lower Pressure Cut-Off Switch; High Pressure Cut-Off Switch; Switch; Switch A/C High Pressure Cut Off
    • Item Weight: 0.50 Pounds
    • Item Dimensions: 1.1 x 1.1 x 2.2 inches
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: 4897617AA
    • Warranty: This genuine part is guaranteed by Mopar's factory warranty.
    More Info
    Fits the following 2000 Dodge Ram 1500 Van Submodels:
    • Base | 6 Cyl 3.9 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS
  • 2000 Dodge Ram 1500 Van A/C Compressor Cut-Out Switches Diagram - 4897612AB
    View related parts
    Product Specifications
    • Other Name: Switch - A/C Low Pressure Cut Off; HVAC Pressure Switch; A/C Compressor Cut-Out; Trinary Switch.; Lower Pressure Cut-Off Switch; Switch; Switch A/C Low Pressure Cut Off
    • Replaces: 5012330AA, 5012330AB
    • Item Weight: 0.40 Pounds
    • Item Dimensions: 2.1 x 0.9 x 0.8 inches
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: 4897612AB
    • Warranty: This genuine part is guaranteed by Mopar's factory warranty.
    More Info
    Fits the following 2000 Dodge Ram 1500 Van Submodels:
    • Base | 6 Cyl 3.9 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS

2000 Dodge Ram 1500 Van A/C Compressor Cut-Out Switches Parts and Q&A

  • Q: How to service A/C Compressor Cut-Out Switches (high-pressure sensor/switch) on 2000 Dodge Ram 1500 Van?
    A: Service of the high pressure sensor/switch should start with disconnecting and isolating the battery negative cable. Disconnect the wire harness connector from the high pressure cut-off switch which is fitted on the line between the compressor and the condenser inlet. Twist off the high pressure cut-off switch from the discharge line and remove it from the vehicle, along with the O-ring seal from that fitting. When putting in a new O-ring seal, first lubricate it with clean refrigerant oil and install it in the discharge line fitting, but use only O-rings recommended for the vehicle and made from the correct material. Lead the discharge line hose through the high pressure cut-off switch's outer body, check and tighten it to 7.5 Nm (5.5 ft. lbs.), plug its connector onto the switch and then reconnect the battery negative cable.

Related 2000 Dodge Ram 1500 Van Parts