JeepParts
My Garage
My Account
Cart
OEM 2000 Jeep Wrangler Antenna
Radio Antenna- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Antennas found
2000 Jeep Wrangler Antenna Base Part Number: 56038660AB
$86.67 MSRP: $136.00You Save: $49.33 (37%)Ships in 1-3 Business DaysProduct Specifications- Other Name: Antenna - Base Cable And Bracket; Radio Antenna Mast; Antenna Assembly; Antenna Base Cable And Bracket
- Replaces: 56008788
- Item Weight: 0.70 Pounds
- Item Dimensions: 12.1 x 3.2 x 2.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56038660AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2000 Jeep Wrangler Antenna Mast Part Number: 56038545AD
Product Specifications- Other Name: Mast - Antenna; Radio Antenna Mast; Mast; Mast Antenna
- Replaces: 56038545AC, 56009081AC
- Item Weight: 0.70 Pounds
- Item Dimensions: 40.6 x 6.2 x 0.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56038545AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2000 Jeep Wrangler Antenna Parts and Q&A
- Q: How to Maintain and Fix an Antenna on 2000 Jeep Wrangler?A: Before servicing or repairing the antenna, first pull the negative wire for the battery away. Disconnect the antenna by pulling apart the metal connectors at the junction for the coaxial cable inside the glove box. Turn the antenna mast counterclockwise to separate it from the base on the right side panel. Slide a trim stick or a wide flat tool under the edge of the antenna base trim cover to unsnap it from the antenna body base. Take out the three screws holding the antenna base to the outer cowl on the right side of the panel. Within the passenger area, push the grommet on the antenna part of the coaxial cable out through the opening in the right inner cowl side panel. Once the cowl is off, pull the antenna body base and the cable assembly out through the hole on the right outer cowlin side panel. To set up the antenna, first reverse the steps you took to remove it and apply 2 Nm (17 in. lbs.) of tension to the body base mounting screws. Once that is done, tighten the antenna mast hardware to 3.3 Nm (30 in. lbs.).
Related 2000 Jeep Wrangler Parts
2000 Jeep Wrangler Headlight Switch
2000 Jeep Wrangler Seat Belt
2000 Jeep Wrangler Brake Light Switch
2000 Jeep Wrangler Horn
2000 Jeep Wrangler Antenna Cable
2000 Jeep Wrangler Fuel Pump Relay
2000 Jeep Wrangler Fuse
2000 Jeep Wrangler MAP Sensor
2000 Jeep Wrangler Antenna Mast
2000 Jeep Wrangler Back Up Light Switch
2000 Jeep Wrangler Door Jamb Switch
2000 Jeep Wrangler Ignition Lock Assembly